HAI/Leviton 4-Relay Module (Mounting)

[broconne]

I am finally getting around to adding garage door control to my HAI system.  I am thinking about buying the 4 relay module, but it isn't clear how I could cleanly mount that in the same enclosure as my omni?  I don't see a mounting board, based on the pictures I don't see anywhere for plastic standoffs..  How do people mount this in a clean way?  
 
I also only need two relays..  So if I can't find a way to cleanly mount this inside of the box, is there a better alternative that can cleanly mount outside the box?  Some of the ELK relays look like they have holes for standoffs and are also a lot cheaper?  Has anyone gone that route?

 

[pete_c]

Good 3M double stick tape off to the side of the panel board. 

 

[ano]

You may only need two relays now, but you will likely need more in the future.  You don't need the Leviton ones as long as the relay has a diode to prevent kickback. The ELK ones are fine as they are diode protected.

 

[LQtechvn]

 
Lot systems, that I was installed using external 12VDC coil din-rail relay working well since 2005.

 

[broconne]

Good 3M double stick tape off to the side of the panel board. 

 
You have a picture you can share of that installation?  

 

[broconne]

You may only need two relays now, but you will likely need more in the future.  You don't need the Leviton ones as long as the relay has a diode to prevent kickback. The ELK ones are fine as they are diode protected.

Awesome, they are a fair amount cheaper. 

 

[pete_c]

Here is a picture showing a CT forum member's 8 port relay attached to door and something else next to battery which could be a single relay.

 

 

[broconne]

Here is a picture showing a CT forum member's 8 port relay attached to door and something else next to battery which could be a single relay.

 

 
Thanks!

 

[pete_c]

You have me neatening my panel can as I have 5 stickem's on the left side and a microrouter on the right side.  Noticed best stickem is that 3M lock.  I have two with double stick tape and 3 with the 3M lock stuff. (2 boards are for the smoke / CO 4 wire detectors, 2 are tiny 12VDC (with LED) power distribution boards and one relay board.  (very crowded).