Latest activity
-
Aano replied to the thread Low priced TV's.I've had two Creality printers. One was the Creality CR-6 SE. It was a Kickstarter printer but I bought mine after Kickstarter. It never...
-
LLarrylLix replied to the thread Low priced TV's.Thanks. If you have experience with other brands, do you find all the quality hype about Bambu printers to be warranted? Now there...
-
LI think it depends on what you are looking for. If you want cheap multicolor just for PLA, a Bambu Lab A1 or A1 mini is a good choice...
-
Aano replied to the thread Low priced TV's.I think it depends on what you are looking for. If you want cheap multicolor just for PLA, a Bambu Lab A1 or A1 mini is a good choice...
-
LLarrylLix replied to the thread Low priced TV's.I've been running a Creality Ender3 S1 Pro for a few years now, and currently considering a multicolour printer but the detailed...
-
LI started 3D printing when someone here talked about it many years ago. Many 3D printers later, I now think I have 6 of them now.
-
Aano replied to the thread MakerBot Replicator.If these are small, you will probably be OK, as they get bigger, then the problems will start.
-
Mmarc g replied to the thread Basic Hardware/Software set up for Omnipro 2 and Homeseer.Good day, I am also looking at integrating my omni pro II with homeseer to be able to control the Z-wave devices since my VRCOP failed...
-
pete_c replied to the thread MakerBot Replicator.Thank you @ano. Been building Wemos D1 Mini / Temp sensor boxes as I have them all over the house. -
Aano replied to the thread MakerBot Replicator.PEI isn't the greatest choice for an unheated bed, but there are some newer beds that work well with PLA on unheated beds, like the...
-
pete_c replied to the thread Low priced TV's.Installed Kodi on Sony. Imported last configuration from TV box. (CoreElec). AOD is working fine with no commercials.
-
DThanks for confirming that part number. I could only see part of a number in a blurry pic but that was enough to confirm a match with...
-
DAre you asking specifically about an alternate 4mb flash chip? -The earlier boards used the 1mb flash chip (M27C801-100F1) -The last...
-
Ddan_n replied to the thread HAI Omni engineer/developer thread.Thanks for confirming that part number. I could only see part of a number in a blurry pic but that was enough to confirm a match with...
-
Bbluelake321 replied to the thread HAI Omni engineer/developer thread.Are you asking specifically about an alternate 4mb flash chip? -The earlier boards used the 1mb flash chip (M27C801-100F1) -The last...
