Recent content by randye007

Hi All,     Just received my Leviton 4 relay module.   Can someone please confirm the wiring?   My guess: J1 to Earth GND on OMNI Panel T1 to EZEye White wire (Digital Output) T2 to EZEye Red wire (+12V) Relay 1 NO to OMNI Zone "-" input Relay 2 NO to OMNI Zone "+" input   Correct?  ...

Correction #3 should be T2 to EZEye Red wire (+12V)

Hi All,     Just received my Leviton 4 relay module.   Can someone please confirm the wiring?   My guess: J1 to Earth GND on OMNI Panel T1 to EZEye White wire (Digital Output) T2 to EZEye Green wire (+12V) Relay 1 NO to OMNI Zone "-" input Relay 2 NO to OMNI Zone "+" input   Correct?  ...

Thanks @ano and @DELInstallations! I've ordered the Leviton 4 relay module. Will report back on results. Thanks -- Randy Sent from my iPhone using Tapatalk

Hi all,      I'm installing an outdoor light sensor to my OMNI IIe Panel.    There are 3 inputs: +12V GND Digital    The instructions say to install the Digital input into the Zone Negative input and connect a jumper from the +12V to the same Zone Positive input.      Before connecting up the...

Hi All,       I upgraded my PC Access, OMNI IIe and Email Notifier Board to the latest versions and in that order. Everything is operational except for my Email Notifier Board. After the upgrade, I was no longer able to access it from PC Access. When I try to retrieve Version / MAC Address info...

SOLVED! Did a reset EEPROM then restored a backup. It's all working now! :) Sent from my iPhone using Tapatalk

OMNI IIe: 3.16 Email notification board: 1.5 It appears as though PCA is unable to update the "Enable Time Sync" field. Possibly a bug in the PCA software? Sent from my iPhone using Tapatalk

Thanks pete_c! FYI - I tried switching the email notifier board with a new one to test. Same behaviour so it's not the board. Sent from my iPhone using Tapatalk

Hi Folks,      I've had this board for 2 years now and never checked to see if the "Enable Time Sync" field was set to "Yes". Well, it wasn't and I find my OMNI IIe system controller time fluctuates from time to time. I understand by setting this field to "Yes" there will be an NTP Sync...

Thanks Ano. Just received a response from Leviton HAI support to the same effect. You are correct. Thx! :) Sent from my iPhone using Tapatalk

Just heard back from Leviton HAI support. With regards to #1 -- outdoor humidity is not displayed on the OMNIStat2. It's a marketing error on the specs. The humidity being referred to is the indoor humidity reading from the internal OMNIStat2 sensor. Sent from my iPhone using Tapatalk

Hi All,      I have two questions regarding the OMNIStat2 Thermostat: I have a 31A00-8 Outdoor Temp/Humidity sensor installed and would like to see the readings on the OMNIStat2. I see the Outdoor Temp on messages line, but no Outdoor Humidity. Do I need to configure something special on the...

Excellent! That did the trick.   Thanks JonW! :)

Hi All,      I have my front exterior lights dimmed to 50% at midnight.    I want to program it such that when the front motion detector gets tripped (between midnight and dawn), the front exterior lights brighten to 100% for 1 minute then return to 50%.      Seems I can brighten for 1 minute...