A

amos

Member
Joined
Last seen
Messages
14
Reaction score
2
Points
3

Latest activity Postings About

    • A
      amos replied to the thread Monitoring utility power?.
      Except I've noticed the M1 doesn't seem to respond to short power drops. I flipped the power on/off for about a second and got my...
    • A
      amos replied to the thread Multiple M1DBH terminations.
      From the install manual: "Two (2) quick connect header pin plugs (J1 and J2) along the bottom of the board may be used for temporary...
    • A
      amos replied to the thread Monitoring utility power?.
      I use a relay with a 120v coil. The relay is plugged in to a non-UPS receptacle. The NC of the relay is connected to an ELK non-alarm...
    • A
      amos replied to the thread OUT 1-4? ELM1GOLD.
      For completeness, from the install manual: Outputs 7, 8, 9, 10, 11, 12, 13, 14, 15, and 16 are low current, positive (+) voltage only...
    • A
      amos replied to the thread Help with DB1HR and Termination.
      Sounds like more of a keypad config issue than a bus issue. As you discovered, for each additional keypad you need to manually assign...
    • A
      amos replied to the thread inexpensive alarm panel.
      I would take your M1 and just leave the wiring and maybe even some of the sensors in place. Say the house is "pre-wired for alarm"...
    Show older items
  • Loading…
  • Loading…
Back
Top