Search results

My PLM is right now controlled by Homeseer and everytime I restart Homeseer, the plugin shows the PLM firmware version on the log

Does this require a newer version of PLM firmware. I bought my PLM a while back and I believe I have version 52 firmware ??? I now that firmware is not upgradeable on PLM.

The 2 ends are attached to my ELK digital input and works great. It already saved me once when I had another leak. Another option would be to use 3 water leaf sensor. This is how I am going to do it, wrap around the PVC with sponges and then place the 3 leaf sensor in triangle to make sure it...

Attached is a cut-out pic. Wrap around the first layer of copper wire then the paper towel to act as insulator and then the second layer of copper and finally the sponge to trap those water that would flow through the pipe. You can use a piece of cloth instead of paper towel.

It is in the far end of my attic, but let me see what I can do.

What I did was wrap 2 copper wires around the pvc pipe separated by 2 sheets of "dry" paper towel so they won"t get in contact and finally wrap them around with sponge (2 pieces to completely wrap them around) so water would be absorbed by the sponge, soak the paper towel wet and circuit would...

Since I have M1XEP and connect to M1 from diff machines on the network, does that mean I need to sync the database to all those machines that I am using.

I just noticed that whenver I disable a rule from ELKRP, I get conflict the next time I connect to the system through ELKRP. Is this by design ??? What is the best practice to temporarily disable elk rules. Thanks

Oh, just to make sure I am clear, no sensor added !!!

Thanks, I knew I am missing something

When I tried to enroll using the keypad, the TXID on the ELKRP remains 0's, although the keypad shows the generated TxID. Am I missing something ???

With M1, I did not have to add anything. When I dip the 2 contacts into the water, M1 changed the state of the digital input.

Check this out: http://www.trossenrobotics.com/store/p/350...t-14-x-30-.aspx

Can someone please let me know the proper way of enrolling crystall wireless devices to M1g xrf2G. I have been using the method of providing the TxID on the wireless setup screen and they seem to work, but the xrf2G manual said to use the tamper switch. I tried using what the manual said...

I have this same issue which I posted here couple of months ago but did not get anywhere. You are not alone. I wish we can figure out how to improve this response time.

RC80 sends report of its status (heating, cooling, off). My dampster is controlled by weeder io board, so when RC80 reports that it is either cooling or heating and temp upstairs is not within comfort zone, HS opens the dampster. Presently connected to ELK, even though RC80 reports its...

From Homeseer with dedicated PC.

Since migrating to ELK-M1G, the WAF is at record low. 1) I have dampster to open and close air flow when needed. When I connected my RC80 to m1xsp, Elk does not have any idea that the hvac is running and there is a need to open or close the dampster. 2) My wife used to be able to see how many...

Now you make me rethink. I am planning to connect my RC80 to ELK and remove it from Homeseer control ! At present, it is running fine on Homeseer but would like to centralize control to ELK.

I have zones configured as analog and they don't show up on the Virtual Keypd Web Interface under Security > Status. Is there a way to get this just like in ELKRP Status screen ?? Thanks