Search results

I posted this in the Vendor forum also but it doesn't get a lot of visibility (or show up in new posts) so I am trying here. Does anyone have or know where I can get an M1XEP? I checked all the usual suspects and they say it is backordered until May. Even ebay came up empty. Thanks!

Apparently the M1XEP (ethernet interface) is backordered until May and I cannot find it anywhere. It is the last piece I need to complete my setup. Does anyone have one they would be willing to sell or know of someone that actually has it in stock? Thanks in advance!

I am having a problem that I am having a very difficult time resolving. My M1G will no longer arm via Ethernet. I initially noticed it would no longer ARM using CQC. I then verified it will not arm using Premise. I then verified it will not even arm using the build in ELK browser interface...

I recently purchased some z-wave capable Schlage locks. I originally thought these were controllable from the M1G using VRC0P but it looks like that capability isn't in the VRC0P yet. However, the MiCasaVerde Vera controller does interface with Schlage locks and looks to be a very robust...

I had a storm come through yesterday in the middle of which my Elk M1G announced Telephone fault. There weren't any lightning strikes at the time and I still had a dial tone on my phones (not going through the Elk), but I disconnected the Elks phone line just to be safe. After the storm, I am...

I am using the M1G with CQC to show status of certain zones, etc. Is there a way in the M1 to track which zones caused a zone to alarm and convey this via the host interface to something like CQC? It appears that the zones only show current status and doesn't reflect if they were the cause of...

I have an Elk M1 Gold using a CADDX NX-448e receiver. I am having a problem enrolling some NX-650 door/window modules and can't figure out what the problem is. I already have a motion enrolled and another NX-650 enrolled with no problems. I can trigger the device and see the receive light on...

Now that the M1G supports the W800 wireless interface, can someone tell me how to configure the M1XSP? I have received my M1G and M1XSPs, but I cannot find anywhere in the latest documentation that tells how the M1XSP should be configured. I am mainly wondering about the jumper device type...

I am on the verge of purchasing an ELK M1G to replace my existing home control solution. I am currently using a W800RF32A interface for wireless comms to X10 devices and a LynX-10 PLC for wired communication to X10 devices. Does anyone know if the M1G will support either of these interfaces...