Search results

  1. G

    Master code lost

    Does anyone know the ( short the board with a wire ) trick to reset the master code? I know it exists as i used to have in one time but i lost it. You shorted two place on the board. I think one was on the main CHIP pin 1 if i remember, or something similar. You used to be able to send the board...
  2. G

    Aux zone constantly sending trouble signal to alarm company

    HIGuys, i have an empty zone 22 ( hard wired expander zone) Its completely blank and set to AUX . But every 4 minutes or so it send a trouble to the monitoring station. I did the usual RAM reset and it was ok for about an hour and then started up again. I'm going to change out the expander...
Back
Top