Search results

  1. R

    z-wave tempprobes

    I'm searching for a zwave temp probes setup.  I need 5 temps and 1RH.  My greenhouse is @100ft from  main home  and I dont  have any extra wires running out there. I will be building a solar water heater  later on and want to bea ble to record and later graph temps.  I have OmniPro and...
  2. R

    HELTUN Quinto 5

    Has anyone ever used this?    https://shop.smarthome-europe.com/en/peripheriques/4450-heltun-touch-panel-switch-quinto-z-wave-700-5-channels.html   Would this thing really handle the load from these:  ...
  3. R

    Yet another Omni gone weird

    My OmniPro with Litolier lighting several weeks ago stopped acting on X-10 signals and then about a week later stopped completing any commands or updating any switch status. The controller thinks it is sending commands and under status show it doing it;s thing but no lights ever turn on or off...
  4. R

    Vizia Rf reverse association

    I've been trying to build a small network. I have 2 dimmer outlets that work fine, 2 15A switches for ice melt and 1 door sensor.   I cannot get reverse association on the 15A switches and dont understand how the door sensor is suppose to work. There is no reverse association shown in the vizia...
  5. R

    Omnipro 2 runs slow

    I've had this issue for several months and cant figure it out. Omnipro 2 panel with Lightolier Compose PLC switches and firewall. System has worked great for 12 years.   Light switches work fine with fast response. Security system works fine.   Automation triggered by motion detectors or door...
  6. R

    BC4 RS232

    The rev2 BC4 has RS232 output, but no documentation of it.   Does this output the IR commands that I can then attach to my Sony DA3000ES? The Sony manual is pretty vague also but does mention power on and off, so I interpolate that it would also receive source and volume.
  7. R

    Bitwise BC4 rev differences - no IR being sent out of box?

    I am trying to use my BC4 Rev1 to control AV equipment. Just finally got the network cable pulled to support it.   I dont seem to be getting any IR commands sent out.   What are the differences between rev 1 and rev 2 on a BC4,  I found a web page once that I cant find again, but I think it...
  8. R

    Here

    I have a 12 year old Omnipro II system. Full security and lighting automation with Lightoleir Compose PLC switches. Several motion detectors that assist in turning lights and such on. Just upgraded board and added a Omnitouch7 screen. I have been working on adding IP cameras and have also added...
Back
Top