Search results

Hi all,      I'm installing an outdoor light sensor to my OMNI IIe Panel.    There are 3 inputs: +12V GND Digital    The instructions say to install the Digital input into the Zone Negative input and connect a jumper from the +12V to the same Zone Positive input.      Before connecting up the...

Hi Folks,      I've had this board for 2 years now and never checked to see if the "Enable Time Sync" field was set to "Yes". Well, it wasn't and I find my OMNI IIe system controller time fluctuates from time to time. I understand by setting this field to "Yes" there will be an NTP Sync...

Hi All,      I have two questions regarding the OMNIStat2 Thermostat: I have a 31A00-8 Outdoor Temp/Humidity sensor installed and would like to see the readings on the OMNIStat2. I see the Outdoor Temp on messages line, but no Outdoor Humidity. Do I need to configure something special on the...

Hi All,      I have my front exterior lights dimmed to 50% at midnight.    I want to program it such that when the front motion detector gets tripped (between midnight and dawn), the front exterior lights brighten to 100% for 1 minute then return to 50%.      Seems I can brighten for 1 minute...

Hi All,     Hopefully this is a simple one ...     I have some logic in my automation scripts to set the HUMIDITY SETPOINT=0 when the OMNIStat2 mode is set to COOL.   Here is my script:   WHEN Main T'Stat SECURE AND IF Main T'Stat SYSTEM MODE IS COOL  THEN Main T'Stat HUMIDIFY SETPOINT 0    ...

Hi All,      I have a question regarding z-wave compatibility between the OMNI IIe and various z-wave devices using the VRC0P-1LW as the z-wave bridge: Somfy ZRTSI - Will the OMNI IIe recognize all the Somfy commands being translated to z-wave? - Does the OMNI IIe periodically poll the Somfy...

Hi All,      Newbie here.      I've been using the Leviton 51120-PTC Whole House Surge Protector along side my OMNI IIe Controller using X-10 to control my lighting. I've started converting to UPB wall switches and tried configuring them from my OMNI Control Pad using the instructions I've found...