Search results

Hi all, I havent bought a switch in a year or so and usually buy the Leviton series UPBs. Luck would have it I get online to pick a few up and theyre nowhere to be found. Can someone fill me in? Need some UPBs for my Leviton HAI Omni Pro IIe controller.... Thanks!

I'm having trouble setting this up. I have three system sensor smoke and carbon monoxide sensors in series. I have my end of line resistor installed at the last detector. My interface panel lights are operating in "normal". I think my detectors and interface panel are worked correctly. So...

Hello All, I'm trying to add up my existing loads to make sure I don't exceed 1.0 amp per "Note 1" on the panel. I found all my loads except the Omni thermostat load. What's the amp from from the main panel to this thermostat? Thanks.

So, I tested out the generator over the weekend.  Natural gas kit works pretty well.  Voltage maintained at 121.7V (122.8V when on gasoline).   I have LED can light bulbs are run through a Leviton UPB dimmer (in two separate rooms - same circuit).   All of this specific wiring is new and by me...

What's are the pros/cons to using each, the 2-wire and 4-wire smoke detectors?   Can I power one of them off the omni panel?  Both?   Daisy chain?   Just trying to get a better understanding and the manual read confusing to me...   Suggestions on each?   I want to get them installed in the house...

Hello,   I just put my first Leviton UPB switch in today and went into my PC Access software to configure.  I'm not sure where/how to do it and from what I'm seeing, I may need the dealer version (which is total crap).  ...

Hello All,   For some reason, I can find what I'm looking for while searching, so I figured I'd post.   I have an Omni IIe panel...   1.  Is there a better or more cost effective remote temperature sensor for air besides the HAI offering? 2.  What are are the offerings for humidity sensors? 3...

I recently purchased the Amico 12 Piezo Buzzer on Amazon as my interior sounder for my Omni IIe panel. I'm getting a pulsating noise from the buzzer as soon as I hook it up. I talked with Leviton and remembered in the quick start guide that a resistor may help the issue. Problem is that it...

Hello,   First post.  I've been trolling the forums often lately and it seems like a very good place for information on home automation...   I recently began installing a Omni IIe board at my house.   First, a general question/comment:  HAI was bought by Leviton.  Is Leviton doing away with the...