Search results

I am trying to connect my hifi to my raspberry pi via serial and control using the protocol attached. the pin out in the documentation states it’s only using pins 2,3,5 across rs-232. when i check voltage on idle txd and gnd i am seeing-5.75v when i thought this should be ~12v. i tried using a...

Hello All,   This might be a stupid question, but how do I "trigger" the page input in the HIFI2?   Thanks in advance

Just wanted to see if anyone has had any luck integrating the NEST API with HaikuHelper and OmniPro II?

Hello -   I recently purchased these LED house numbers and wanted to know if anyone has had any experience with wiring and programing these. I want these lights to come on at sunset everynight and turn off at sunrise. I dont think that i can pull power from the OmniPro II so was thinking i would...

Hello All -   Goal: When the doorbell is pressed show a picture in picture of the front door camera and play brief audio file through HFI2.   Objectives: Digital brodcast of my CCTV feed from my DVR security system. I currently have comcast (xfinity) cable and there are two open channels (950...

Hello All -   I just wanted to get some feedback on what type of wire I should run to power my doorbell and outdoor cameras? I am down to the studs and getting ready to start running all of my ethernet and security wire for Omni Pro II and HIFI2. I just wanted to get some ideas for how to run...

Hello All -   I was wondering if anyone has came across an IP internet tuner that I could use a source for my HIFI2? I am looking for something that has the push pins that I can put right into my leviton structured media panel and would only draw energy when that source is selected.   Thanks in...