Recent content by lewisjd

WOW, thanks for the response Kent! I've been reading up on the VLAN capabilities of this switch as well as access control lists. (I have VERY basic Cisco knowledge) I am most definately going to have fun with this piece of hardware. :-) That DLink 24port that you have is really nice. That might...

I was in need of a new network switch since I ran out of room on my measly 5 port DSL router. I was looking at some nicer Netgear, etc but I ended up getting an end-of-life Cisco Catalyst 2980G from work. Does anyone have any experience with these switches? Any pitfalls?

http://www.amazon.com/exec/obidos/ASIN/B00...mmbevigaotst-20 Not sure of the quality of this product, but $700 discount is a pretty big chunk of change to save!

its not that the hole is too small, its just right for my sensor. the issue is that the wire goes through 2 2x6's and then through the trim. i am unable to push the wire back into the hole for some reason. i dont have the link off hand, but they are tane micros (sorry for the confusion). i think...

So here's my issue. When my builder trimmed everything out, he jus drilled a hole in the frame and pulled the wire through fortwo of my sensors. i have the tang micro recessed mags. I tried to see if there is any play in te wire so I can feed it back in after connecting the mag, but there isnt...

has anyone seen these yet? looks pretty neat. i wonder how difficult it would be to interface one of these with Elk? http://www.silverpac.com/products/smart-energy.html

I ended up getting a Greenlee DM-40 Digital Multimeter. It was on sale for $29 and had read some good reviews on it. Plus it included a thermocouple, which could come in handy. Next stop, house!

Yes, let me clarify. I have the contacts installed/terminated and the 22/4 run to my home run location. I don't have my Elk yet. I wanted to test to make sure the wiring hasn't been fubar'd by the insulation guys, other workers, or by me ;) ... I used those little gel filled telco crimps (which...

I don't have a continuity tester at my disposal, but I have plenty of spare parts lying around. I was thinking about wiring up a quick battery/led circuit to test my alarm contacts. When magnet is on, led lights up, take magnet off, led turns off. Just a simple continuity test. I used the Tane...

hahaha. ran out of 22/4. had to go to HD to get some at ourageous prices! going back today to modify the j-boxes and run a few more cables.

well yeah. what i meant was since he is running the initial group of cat5/rg6 to the typical locations, he is going to drill a few extra holes for me to use as runs for my LV stuff.

well, i have a team of 5 guys helping me out, so im hoping we can get it banged out. the electrician is going to predrill a lot of holes for me, so that will same some time.

so walkthrough went good. except they said they will be done saturday and i have UNTIL MONDAY to get my stuff done. time to scramble!

So I have the walkthrough tomorrow morning at 8am. Any advice on things I should request/look for? I'm homerunning roughly 50xCat5e, 50 RG6, 2000' 22/4. The typical network/video/security installation. Suggestions for power @ panel?

i saw that, and thanks! i bought ~450 ft for $0.08/ft. :-)