I have the bell wire for my garage door opener switch wired to the NO and COM terminals of an ELK 960 delay timer (set to 1 sec) and the trigger is wired to an output of my HAI OPII.
I have a button and accompanying line of programming which says:
WHEN <BUTTON>: <OUTPUT> ON FOR 1 SECOND
This setup works fine, but i've noticed if i remove and restore power (and battery) from my panel, the garage door opens. I'm guessing the HAI is triggering the delay timer as part of some startup sequence.. is this true? if so, any suggestions for how I would make this more robust?
For now, i've added additional lines of programming to notify me if the door is open "too long" and/or to auto-close if the HAI is armed.
I have a button and accompanying line of programming which says:
WHEN <BUTTON>: <OUTPUT> ON FOR 1 SECOND
This setup works fine, but i've noticed if i remove and restore power (and battery) from my panel, the garage door opens. I'm guessing the HAI is triggering the delay timer as part of some startup sequence.. is this true? if so, any suggestions for how I would make this more robust?
For now, i've added additional lines of programming to notify me if the door is open "too long" and/or to auto-close if the HAI is armed.