Search results

  1. G

    Russound CAV6.6 Replacement Audio / Video

    Wanted to see what other users maybe going to as their CAV6.6 units go out for distributed video and audio. Our system is currently a CAV6.6 with six sources and six zones. The complete system is connected to an HAI OmniPro for distributed control along with keypads in the zones.   The new...
  2. G

    HAI RC-2000 with Multiple Remote Temp. Sensors

    Can you hookup more than one remote temperature sensor to the RC-2000? In the installation guide I see where you can wire up a remote sensor to the thermostat on terminals 10 & 11. It mentions this takes an average of the on board sensor and the remote sensor. However when I look at the setup...
  3. G

    Video Recording and Interface to OmniPro

    I am been trying to decide what is the best route to take in implementing video recording for my existing cameras and also have the capability to view the video on my HAI touchscreens, I-Pads and I-Phones. Below is the hardware I have. I orginally was planning on using HAI WL3 on a server but...
  4. G

    UPB Phase Couplers and Repeaters

    Running into some signal strengh issues on the other phase. I have a HAI phase coupler installed. When running test with Upstart will get signal strength levels less than 5 in some instances. Was looking to add a repeater to the system but see the issues concerning using Gen 1 switches with the...
    • ghanson
    • Thread
    • Replies: 4
    • Forum: UPB
  5. G

    HAI to Somfy Universal RTS Interface

    Looking to see if anyone has had any luck making the HAI OMNIPRO II communicate to the Somfy Universal RTS Inteface over 232. I am using the OMNIPRO II as my primary house controller. I have 10 window blinds with Somfy RTS motors and want to automate the control of these through the HAI. I...
Back
Top