Search results

Hello all,   My OmniPro II all of a sudden failed at 2.30am this morning.  The control panels were beeping and showing "NO CONTROLLER DATA" and I lost access to the unit on the network.  Powered on/off (removed battery) but the status light appears not to light either.  I looked around and...

Current Setup - many of which is now 10+ years old and has done a fabulous job over the past decade   HAI OmniPro with lots of hard wired zones and a few wireless (less than 5) HAI OmniPro subpanel to cover another part of the house A couple of HAI thermostats a bunch of 5.7e screens (about 6)...

Current Setup - many of which is now 10+ years old and has done a fabulous job over the past decade   HAI OmniPro with lots of hard wired zones and a few wireless (less than 5) HAI OmniPro subpanel to cover another part of the house A couple of HAI thermostats a bunch of 5.7e screens (about 6)...

Hello,   I have seen the other posts about using flags to create delays prior to code blocks.  Is there anyway to create a delay inside a code block?   When Flag Off THEN DO1 THEN DO2 THEN DO3 WAIT THEN DO4   I have somfy blinds with a RTS repeater and I find that the HAI sends the commands to...

Hello,   I have a OmniPro II running 3.16 and I am having some intermittent issues with the consoles.  Sometimes they beep when the entry delay is active and other times they don't.  In the last few weeks I'm noticed that they never seen to beep.   Is there a setting somewhere I am missing for...

Hello,   Let me explain what I have and what I'm trying to do   I currently have a HAI OMNIPROII that is hooked up to a HAI Cell adapter (HAI C3).  The cell adapter analog port is hooked to a Nextalarm ABN which routes the calls over the internet.   Currently what happens is all calls go to the...

Hey all,   Quick question.  I have been analyzing my zones and trying to make sure I have everything covered - we live in a pretty rural area and the house is not visible by neighbours.   I have a HAI remote temp sensor that is mounted at the back of the house, about 7ft from the ground.  This...

Hello,   I've been digging around for a bit to see if I can figure out a way to get the tripped zone(s) name to display on the 5.7e touchscreen.  Currently it just flashes a screen telling me that the alarm was tripped with no useful information.   The regular basic console shows the...

Hello All, I'm hoping someone can help me. I'm trying to wire an EZEye photocell to an HAI OmniProII security zone. I'm using the digital output from the device but the alarm is always showing the zone as not ready. The board won't let me post a link to the manual but if you go to google...

Hello all, Quick question. On my HAI OmniPro under the digital communicator I can specify Phone Number 1 Account 1 Phone Number 2 Account 2 What I want to know is will it call Number 1, then if that fails call Number 2? or will it always call Number 2 regardless of the result from Number 1...