Search results

I posted here years ago when I had severe UPB signal problems.  We traced the signal sucker to a UPS.  For the last 4 years or so, things seemed be ok, but now we are back to 50% of UPB units are dead, and signal levels are 2 for some devices.  What's even stranger is that some devices are fine...

I'm building an application that will display a graphic of the home and property with real-time status display of security, devices, etc, represented on the floorplan. Writing in C# Visual Studio 2010. I am using "notifications" to get real-time status updates from the panel. So far so good...

I have the HAI 75A00-1 card readers. I'm curious though. There are 3 inputs to the card reader, Request to Exit, and aux 1, and aux 2. I know what Request to exit is for, but what do the 2 aux inputs do? They show them in the manual hooked up to contact switches, but not a word about what...

I have a house with about 20 UPB devices. Everything has been perfect for years. I have an HAI phase coupler (split phase in my house). Woke up yesterday and 15 of the devices were not responding to commands. They do operate normally locally. At the same time I found a circuit breaker...

System is OmniPro II, 3.2b. I recently added a card reader to replace a data chip reader that has been in use for years. When we swipe a card, the reader blinks RED-GREEN-RED-GREEN then goes all RED. (even though the system is disarmed). The door does NOT unlock. Then, swiping a second time...

Is there any upgrade policy to trade in old OmniPro II boards for new versions that have flash memory? I just upgraded to 3.2b a week or two ago, and I am experiencing the OR bug. I have upgraded the firmware 4 or 5 times over the past 10 years, and replaced the whole board once (when all the...