Search results

Hi, My Elk M1 Keypad is showing a Low Battery message. Does it mean my battery is dead? My system is 4 years old. If I need to buy another one, witch model and where should I buy it? Thank you.

Hi, My friend is looking for an alarm system for his 2nd house. It's an open area design with a basement. He need the following: A Wireless system that can have at least 2 motions detectors, 2 doors contacts, a few window contact, one or more panic buttons. A big horn. A keypad near the door...

Hi, Do you know if the Cinemar forum web site is offline? I'm trying that link http://www.cinemaronlineforums.com/forum/and I'm always receiving a page not found... That's strange. Stef

Hi, A friend of mine would like to control is amp and cable box from his touch screen in the kitchen. He's not ready for a good (but expensive) touchscreen interface like Mainlobby or CQC. He don't have any HA software. What he need is a simple program with a few buttons to turn on/off...

Hi, I'd like to detect the power status of my 2 receivers and my 3 cable box. They all have a switch power plug on thier back. I already have a few cat5 runs between the receivers, cable box and my wiring panel. I want to connect this to either my Elk M1 or my SECU16. They are both connected...

Hi, I used to control all my A/V stuff that are mostly installed in the living room from my Ocelot. I also have an IR network with IR sensor outside the A/V cabinet. The output from the living room cablebox was also feeding the kitchen TV. On the boxing day I bought a new Sony HD TV with an...

Hi, I need to temporary unplug my Elk M1. I did that this afternoon. I had connected it to the telco with the RJ31X. Now that the M1 is unplug, the phone is'nt working anymore. Is there a way, without removing the RJ31X to make the phone work again? Is it possible to put wires across the...

The first time i looked at the options at the keypad after connecting everything, it was late at night and the familly was asleep so I changed some options that mute the output1. Now i can't found how to unmute. Is there a way to reset the M1 and get it back to the factory setting? Now that i...

Hi, I'm still in the process of installing my new Elk M1 gold. I'm trying to use the ElkRP program. I can't connect ElkRP to the M1. I thought that it was a cable problem because I had used a cat5 with RJ45 to DB9 module at each end. My cat5 cable was a bit more that 50 feets. I tryed with...

Hi, I have a client who want to install outside speakers. His electrician pass a 16-4 speaker wire from the receiver to his patio. He would like to have a volume control outside near the patio. My problem is that I can't find any weatherproof box (with a cover, idealy a clear one) deep enough...

Hi, One of my custumer want to renovate his TV room. He want to install a home theater. I already installed ceilling speaker in the kitchen, dinning room and the living room. He want in ceilling speaker in that room too. Look for the green circle near the foyer. My question about rear...

Hi, I am installing my new Elk M1 Gold. So far so good! I'm not sure where i should install the speaker. - Should I install it near the keypad so i can here message when using it? - Should I install it near the bedroom. But I'm afraid that it would wake-up everybody in the morning when I...