Search results

I've an Elk M1G setup that I'm wondering about. I'd like to ask your opinions and either leave it where it is or make some changes but at a larger expense. The home has a fully attached Garage where the hot water, furnace, power panel and home network center all are located. It has two...

Anyone else have any additional information that they could share? Of course, if you are under NDA and can't say anything, I'll understand. Would be interesting to find out if this will possibly interfaced to an Elk M1G using Elk's ethernet interface...

http://www.usatoday.com/money/industries/e...bs_N.htm?csp=34 I'm going to have to actually lobby against this with all of my representatives. Can't believe it but I've got to go against the grain regardless of the impact in terms of my "carbon footprint". The heart of the matter is that a...

Does anyone know if the System Sensor 2WTA-B is compatible with the ELK M1G? I know that the sounder may restrict the number of smokes to a smaller number if compatible, but I only need to support 7 of them. Here's the System Sensor webpage...

Noticed the new Elk-M1 & EZ8 Control Firmwares - Ver 4.5.4 (For NX Wireless Receiver) 5.1.4 (For ELK-M1XRF Wireless Receiver) were posted today. Thought I'd mention it for fellow M1 or M1EZ8 owners.

Hello, I know I'd started another thread, but I realized after starting that thread that I'd like a raise of hands (or a poll if virtual hands are not really possible) for what standard I should start with. 1. I'll be using an ELK M1G system to controll the lighting solution. With a 2800...

Now that I've moved to an Elk M1G sercurity/automation controller, I'm seriously looking at implementing the lighting controlls that I've been intending to do for some time. I've a few (very limited and not a problem to switch "no pun intended" to something else) of X10 and Insteon hat I've...

Hello fellow Cocooners, I've an older Caddx NX-8 security panel that I'm upgrading to an Elk M1 (don't worry, I've access to the EOL at each sensor and can replace for correct values). The question I have, is while I'm waiting for my Elk to ship, will it fit in an existing Caddx can? It's...

My home is already pre wired with the 120VAC 3 wire Firex smoke detectors. They all alarm as one and also run off of battery during a power outage. Rather than remove them all and replace them with either 2 or 4 wire smokes, does anyone know of a method on how to interface them to a hardwired...

http://www.elkproducts.com/products/elk-mm447.htm This ELK-MM447 has the MM443 Magic Module, MV480 voice annunciator and the ML8 Caddx Security Interface all built into a single module that fits into a Caddx Xpand-A-Can. Has anyone else had experience with this product? Any feedback positive...

Hello fellow enthusiasts and professionals, I recently have upgraded my home with a structured media center (Home was built in late fall of 2000, my Wife and I purchased it two years ago). I did a full retrofit on the wiring after I through a fit. When intending to add another line to...