Search results

Some time ago there was a Web Control app.  Is it still available and if so where can I find it?   Thanks in advance

I have had a CAI Web Control board for a couple of years now.  Mostly I use it to open and close my garage doors.  I have used a couple of temp sensors to monitor temps around my house.  Now I want to take it a little further.  I want to monitor my pool water temp and start my solar pump, keep...

I used the manual example and the output doesn't change.  Am I missiing something?  Here's my code   START TSTEQ OP1[1000] 1 SET OP1 0 TSTEQ OP2[1000] 1 SET OP2 0 TSTNE IP4[50] VAR1 CALLSUB BTN_CHG TSTEQ IP4[1000] 0 CALLSUB BTN_DONE CALLSUB LITES END...

Hi all   I want to use a button as an input to my CAI.  I already have a setup where I tell the CAI over a web page to change an output to close a relay to open one of my garage doors.  I use it to open/close either on demand.  I would like to setup a single button in the house connected to a...

I want to set this system up to monitor my heating system and possibly control it in the near future.  I have several of the sensors hanging out all over the house, but they are just that, hanging off the wire.  What do yu guys use to house these small temp sensors?  I have a Stadler Viega...

Ok so I have 6 sensors connected and I had a pretty hard time getting them all connected to the board. I want to connect a couple more. What do you guys use? I am thinking about some terminal strips to break it down to a couple per terminal. Maybe I will create a board to connect them to...

I know I can get all the board info using getall.cgi and I can get a single with gett1.cgi. I am trying to setup an android interface. Is there any way I can get CSV outputs from the board? Thanks

Can someone suggest where I can get temp sensors for the CAI board. I have several ideas and am on a tight budget. Thanks for any suggestions!

I purchased a WebControl and a two relay board to interface with my two garage doors. I have just the webcontrol fired up and I can log in and poke around. I even figured out how to change a TTL state. Initially I would like to use my android phone to control the doors using a couple of...