Search results

  1. O

    Sprinkler wiring to Omni Pro confusion

    I've had my 8 sprinkler zones run by my OP2 for years in an expansion panel and 8 relay board. Over the years, I've had a few solenoid failures each year. While changing a couple this spring, I tested the leads with the zone off and notice I'm getting 12-15V AC. When the zone is on I get 26V. It...
  2. O

    Basic Hardware/Software set up for Omnipro 2 and Homeseer

    I'm looking for some basic guidance on what I need to add Homeseer to control my OmniPro2 panel so I can integrate some other systems into HS at some point. My OP2 was installed in 2006. My set up controls security, fire, about 20 HLC switches, pool pump, outdoor lighting, sprinklers and a few...
  3. O

    HAI Dimmer problems

    I have an OP2 setup with 30 or so HAI dimmers around the house. I've been having issues with couple of newly installed dimmers on a single circuit that feeds multiple light loads around a back door.  One HAI dimmer controls "Back Door Outside" - 2 recessed lights and 2 sconces. The second...
  4. O

    HAI Omnistat questions

    I have an omnipro ii panel and have recently aquired a couple of rc2000's.. Somewhat of a HA rookie and trying to figure some of the install out. First, the install manual references a comm jumper. My stats dont have them. Did early versions not have the comm jumper? Currently im just using...
Back
Top