nemesis
Member
I appologize if this is a simple question, but I have been searching this site and the net forever. How do you install the second 10A06-1 expansion board onto an OmniPro II? I am assuming that the ribbon cable just plugs into the second ribon slot on the first expansion board as well as the second board. I am also assuming that you move the jumper pin on the second expansion board to 2. That being said I cannon find confirmation of this anywhere. These are just my guesses.
Also, where are you guys physically mounting this board? Do you stack it ontop of the first board making it impossible to get at the first boards zones or do you get longer ribbon cables and mount it seperately? Thank you for your help!
Also, where are you guys physically mounting this board? Do you stack it ontop of the first board making it impossible to get at the first boards zones or do you get longer ribbon cables and mount it seperately? Thank you for your help!