Recent content by lemahoney08

So for the second keypad, you hook it up the same way on the keypad side? Then put both keypads corresponding wires into the correct terminals on the main panel board? Because there are more than one keypad what should the jumpers be set as?

I am very new to ELK security and trying to setup my first system. Want to run some things by you guys to make sure I am not hooking something up wrong and fry my elk.    Where I am at. I have 3 door sensors, one motion, and 2 keypads for right now. All wires are wired all the way from the...

So to confirm that I have all the wiring ran that is needed. Here is a description of my system:   ISY994i + ELK M1 running some insteon switches for each room. Then 3 door sensors, two motion detectors, and 2 keypads.    The switches are wired as normal, so I am fairly sure everything there is...

Also one other question before I drywall, is the one speaker that comes with the M1 enough to transmit the sound over 700 sq ft?    I was looking at the IntraSonic I600-BASICPAC Music Distribution Package. Is there a way to get the elk sound output to be an input into this system if the stock...

This will be a smaller install in a smaller apartment, just getting my feet wet on a more simple setup. So I will homerun each keypad. By proper termination, you mean setting the jumpers on the M1 board correct? nothing special needed at each of the keypads?

I bought an ELK M1 GOLD with the standard keypad. I also added an additional touchpad keypad. The touchpad for the house, the keypad for the garage entrance. My question is, do I run the cat5 from the elk box to each keypad, or from elk box to the first keypad and then on to the next keypad?