Recent content by edselrt

To control the gate you would need a low current relay Altronix rbsn-ttl connected to one of the outputs of your OP2. You need also a heavy duty garage door contact to check status of gate (open or close). To detect a vehicle you need a Hai wireless vehicle detector and a HAI wireless receiver

So i did two more installs using C3 cellular communicator second gen (part number 70A00-2). This communicator is worse than the first version. The first site is connected to Omni pro II while the second site is using omni iie. Both sites are using Rogers GSM sim. If you go back to my first...

1.yes 2.yes

+1 I have a need right now for something like this. because the shop is so big its hard to track which zones are open

you are right. thanks for correcting me

so i just encoiuntered this scenario. if say you have three phone numbers programmed in the omnipro dialer and the first number has a voice mail.if there is an alarm, the panel will dial the first number and will not continue to dial the rest of the phone numbers. There is no way to set the...

Use hai triggers

Go with Zigbee. I just finished an install using kwikset with Hai zim

the company who did the rough-in must have a wire list. Maybe your builder can help you get that. Otherwise, you have no choice but to trace the wires yourself. I normally don't trace all the wires. Install door contacts and just trace the motion and keypad wire. Power up after you install the...

Hi Ken, Welcome! Hai is more commonly available here in Vancouver than Elk. If you need help finding these items Pm me

This issue is very similar to mine. this happens on my iphone 4. My other phone (3gS) doesn't have this issue.

Bitwise box + ipad is an expensive solution if it can only do a one way serial communication to omnipro panel. I know a Hai driver is in the works but who knows when its available. Haiku is your best bet as of now

On another thread i asked for Haiku url scheme so i can just launch haiku from within bitwise Gui but that solution is not seamless. What i am thinking now is if it is possible to use bitwise gui templates and communicate to Hai by using haiku helper as a "gateway".

Yes. I want to use the graphics. These graphics talk directly to the bc4 hardware and the bc4 can talk to your haiku helper using java script? Here is a link to bitwise gui http://www.bitwisecontrols.com/touch.php

Will Haiku helper integrate to existing GUI? I will use Bitwise controls GUi template and embed the javascript functions on each buttons that i want to use. Basically, Bitwise talks to Hai thru haiku helper