Recent content by Davew01

Serial.

As best as I can tell, PC Access 3.d will only communicate with HAI firmware based panels and not OnQ panels.

Will do. Thanks

Does PC Access 3 work or communicate with both HAI and OnQ OmniPro panels and firmware?

Does PC Access 3 work or communicate with both HAI and OnQ OmniPro panels and firmware?

Thanks Dwalt. I appreciate your help. Dave

Does anyone know if an Aegis Console Keypad will work properly/communicate with an HMS 1050 OmniPro panel. I would to add an additional keypad to my system and a friend of mine has an Aegis kepyad, but I do not want him to mail it to me if it will not work with OnQ panels. Thanks Dave

Thanks

Hello, does anyone have a copy of a HAI Weblink I or II disk or diskettes. I was moving to a new PC after a hard disk failure and need to reload Weblink on my new PC. I went to reload my Weblink and my disk has a scratch on it and will not load. Any help would be appreciated. Thanks. Dave

Thank you for moving my inquiry to the HAI Forum. I temporarily disconnected the new cellular transmitter and still could not communicate with the panel. No firmware changes were made during the installation of the new 4G transmitter. The installer code and PC Access code are correct when...

Hello everyone. Yesterday my PC Access Installer version 1.9A quit communicating with my OnQ 1050 panel. Main panel and serial interface board seem to be working. I get a blink on the RCV light on the serial board when I trying to communicate with the board, but no response. PC Access has worked...

Thank you for your quick and informative reply.   I guess I  will try to find someone who might have an old copy of OnQ HomeView software.

I have an  OnQ HMS 1050 panel installed at my house. It is the version before an Ethernet port was included on the board. Does anyone know if the HAIKU software will communicate with the board or whether HAIKU can communicate to the board's serial port?   Dave