I tried to find one of the VRCOP units and didn't seem to find one. My phase coupler was fried for who knows how long, bought a new one thinking that was my issue, but it still didn't work.
I know what you mean about keeping the OMNI, I love the unit and don't want to ever have to get rid of...
You are never going to believe this, IT'S FINALLY WORKING AGAIN!!! It was the ProLink setup. I tried it no less than 3 times during all my testing and it never seemed to work and I thought I was just being silly trying the same thing over and over. I suspect I may have had another link in...
At the time that PCA was connected via serial, I did not happen to test the X10. I had pretty much given up on it and was focusing on using the serial for a link to HomeSeer using the remotes. I was sending commands using the Send Command function from PCA to see if I could receive anything on...
The MSC-400 communicates with a terminal emulator on the laptop just fine. I then used the same laptop and connected directly to the panel and can see the small status LEDs light up as I send serial data. But still no response. I then created a button to Send data out the serial port to test...
I have Universal MX-3000 remotes all over the house that using a MSC-400 send serial commands to the OMNI. The system worked great for years until X10 just completely quit altogether. I never tried to use the remotes to control anything for years since the X10 was so problematic. Now I want...
I must be an idiot. I have the dealer software, downloaded it again tonight from your link. Still seems to be be the same version as I have 3.17.3.861 and I don't see anything about a clock sync.
File 6.6.0.7609
I don't suppose anyone has any good way of syncing the clock on the HAI OMNI? My clock is off minutes a week. Drives me nuts having to correct the time all of the time. I've played with the adjustment, but it doesn't seem to help, maybe I just need to play with it some more. I'm a bit...
I found HomeSeer with a OMNI plugin that should be able to take over the lighting and other controls while still using the HAI for it's own automation. This should help somewhat "future proof" the system, at least for a little while.
I just can't seem to get my X-10 to work anymore. Tried new serial modules, phase coupler/repeaters, nothing it getting through anymore. I'm looking in to Z-Wave, but is the Leviton VRC0P anywhere to be found? I'm dead without it. I want to use the Omni IIe to be the controller.
Is this...
I just happened to notice mine was dead completely. There are two protection diodes and a 5V regulator that are cooked and dead shorted. I was afraid to spend the money and time replacing those parts only to find out the rest is bad because of their failure. So I bought a used one that does...
I may try the UPB if others can say that it works much better than X10. I was just leary of another powerline communication knowing I have some noise issues especially with the VFD (Variable Frequency Drive) unit for my well pump. This thing convert 120VAC into a variable frequency 3-phase...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.